R6,844.33

Victron – Multiplus – 430w-12V Pure Sine Wave Inverter/Charger

Description

SPECIFICATIONS:

Model:  Victron – VIC-MULTI-12-500-20-16
Rated Power:  500VA – 430w

Input:
Voltage range: 187-265 VAC
Input frequency: 45 – 65 Hz

Output:
Output voltage: 230VAC ± 2%
Surge Power:  900w
Efficiency (Peak): 93 %
Frequency: 50Hz ± 0,1% (1)
Waveform: Pure sine wave

Battery & AC Charger:
Battery Voltage: 12 VDC
Floating Charge Voltage:  13.8 VDC

Solar Charger:
None

Physical:
Dimension, D x W x H (mm): 311 x 182 x 100 mm
Net Weight (kgs):  4.4kg

Spec Sheet:  Victron Datasheet-MultiPlus-500VA-1200VA-EN

 

  • Description
  • Reviews (0)

Description

Proven reliability
The full bridge plus toroidal transformer topology has proven its reliability over many years.The inverter is short circuit proof and protected against overheating, whether due to overload or high ambient temperature.
PowerControl – Dealing with limited generator, shore side or grid power  800VA/1200VA)
With the Multi Control Panel a maximum generator or shore current can be set. The  MultiPlus will then take account of other AC loads and use whatever is extra for charging, thus preventing the generator or shore supply from being overloaded.
PowerAssist – Boosting the capacity of shore or generator power (800VA/1200VA)
Where peak power is so often required only for a limited period, the MultiPlus will make sure that insufficient shore or generator power is immediately compensated for by power from the battery. When the load reduces, the spare power is used to recharge the battery.
High start-up power
Needed to start high inrush loads such as power converters for LED lamps, halogen lamps or electric tools.
Search Mode
When Search Mode is ‘on’, the power consumption of the inverter in no-load operation is decreased by approx. 70%. In this mode the Multi, when operating in inverter mode, is switched off in case of no load or very low load, and switches on every two seconds for a short period. If the output current exceeds a set level, the inverter will continue to operate. If not, the inverter will shut down again.
Programmable relay
By default, the programmable relay is set as an alarm relay, i.e. the relay will de-energize in the event of an alarm or a pre-alarm (inverter almost too hot, ripple on the input almost too high, battery voltage almost too low).
Remote on / off / charger on
Three pole connector.

Reviews

There are no reviews yet. Add a review