Victron Battery Management System VE.Bus BMS

This cable is intended for on/off control of the Skylla-i when the source signal is high when the Skylla-i must be on, and low or free floating when Skylla-i must be off.

Specifications:

Maximum input voltage: 70 V

Minimum input voltage needed for switch on: approximately 6 V

Switch off level: input voltage must be less than 1 V or must be free floating

Description

Supplier Part No:BMS300200000

Each individual cell of a LiFePO4 battery must be protected against over voltage, under voltage and over temperature#
Victron LiFePO4 batteries have integrated Balancing, Temperature and Voltage control #acronym: BTV# and connect to the VE#Bus BMS with two M8 circular connector cord sets#
The BTVs of several batteries can be daisy chained#

The BMS will:

  • Shut down or disconnect loads in case of imminent cell under voltage
  • Reduce charge current in case of imminent cell overvoltage or over temperature #VE#Bus products only, see below#
  • Shut down or disconnect battery chargers in case of imminent cell over voltage or over temperature